Your browser is not supported anymore.

We suggest changing from Internet Explorer to another option. The Internet Explorer browser is no longer supported by Microsoft. Please install or upgrade one of the browsers below.


Epiroc introduces the fastest DTH hammers on the market

COP M-series hammers
The all-new COP M-series DTH hammers are faster, lighter, more service friendly and longer lasting than ever before. On top of that, the new range of DTH bits are designed with a unique solid shank that further enhances penetration rate and durability.

By simply exchanging a few parts, each and every COP M-series hammer can be quickly and easily adjusted to different compressor air pressures and air volumes. This two-in-one feature makes the new DTH hammers fit all rigs and climates.

""The adjustable feature of the COP M-series hammers comes in handy when mining companies run different size rigs, and operate mines at different altitudes. Our customers can stock fewer hammer variants, allowing reduced stocks and less capital employed""

Fredrik Gransell, Product Line Manager DTH Equipment at Epiroc
The COP M-series hammers come in three sizes: 6", 7" and 8". By choosing the right hammer, optimum drilling efficiency can be ensured for the entire range of 165 mm to 254 mm bits.

"All the COP M-series hammers show outstanding improvements in penetration rate and service life. COP M7 is particularly successful, since it bridges a known productivity gap between 6" and 8" hammers", Fredrik Gransell continues.

The new, patented air cycle of the COP M-series DTH hammers replaces a design that has been dominant on the market for more than 40 years. This innovation enables a considerably faster cycle, resulting in a shorter, lighter and faster hammer than ever before.

One of the key features is a smaller and shorter piston, which allows the hammer to strike the rock at much higher frequency. At the end of the day, much more impact force has hit the rock, more meters have been drilled, and uniquely enough, the equipment has had a much smoother ride. Finally, the hammers are 25 percent more compact and 30 percent lighter, which make them easier and safer to handle.

The all-new range of DTH bits feature a patented solid shank, a new external airflow system, and special, patented Enduro buttons. As a result, the COP M-series bits drill faster, last longer, and offer longer intervals between regrinds.

"At one gold mining test site, COP M8 bits had a 50 percent longer service life. This is solid proof that our new COP M-series bit technology works even better than expected, says Fredrik Gransell.

Both tests and initial volume production indicate that the COP M-series DTH hammers and bits offer great increases in penetration rate and service life. COP M6, M7 and M8 have proven themselves in all kinds of rock, in all kinds of climates, and with a great variety of drill rigs.

"We are confident that the COP M-series DTH hammers will offer our customers the lowest cost of ownership", concludes Fredrik Gransell.

For further information please contact:

Fredrik Gransell

Product Line Manager, DTH

Phone: : +46 (0) 72 145 41 82


Karin Cox

Global Communication and Brand Manager

Phone:: +46 (0)72 084 24 85


COP M-series International 2019 Press release